Here you can learn more about Sierra, read frequently asked questions, watch videos, and download the most current Sierra User Guide.
NOTE: The Bluetooth streaming music section of the User Guide only applies to Sierra headsets with serial numbers greater than 500012210. The FlightLink section applies to headsets with serial numbers greater than 500006162.
The Sierra headset requires two AA batteries. Use alkaline batteries for best performance, although lithium batteries may provide improved battery life in colder temperatures. We do not recommend using rechargeable batteries or mixing battery types and brands. A set of batteries provide an average of 40 hours of power. However, Bluetooth usage will impact battery life.
If you lose power at any time, Sierra will continue to perform as a passive headset. When batteries begin to run low, the power LED flashes red, and the headset will continue to operate. Install new batteries as soon as possible at any indication of low batteries. We recommend you add checking your headset batteries on your preflight checklist.
Sierra’s Stereo/Mono DIP switch is probably set to Stereo while your audio panel is transmitting a mono signal. To fix this, change Sierra’s Stereo Mono DIP switch to Mono. This setting does not affect music or audio from auxiliary devices; you can hear stereo sound on auxiliary devices even when the Stereo/Mono DIP switch is set to Mono.
You can think of microphone gain as a volume control for your microphone. Soft voices might benefit from an increase in gain in order to improve audibility and, in some cases, to break squelch; louder voices may need little to no gain increase. Equipping each headset with its own gain adjustment helps balance loud and soft voices in a multi-headset environment.
To adjust mic gain, remove the foam windscreen on your microphone and then remove the small cap next to the Lightspeed logo on our microphone to reveal the adjustment dial. Turning the adjustment dial clockwise will increase gain and turning it counterclockwise will decrease gain. A little adjustment goes a long way, so move the dial in small increments (think one-hour increments on a clock face) and test it in your aircraft. When you are satisfied with the adjustment, replace the cap and foam windscreen.
Note: The microphone will not transmit unless plugged into an intercom.
Your headset may not be in pairing mode. Some phones prompt for a pass code without checking for pairing mode. When the phone cannot pair with the headset, it rejects the passcode. To enter pairing mode, you must start with Bluetooth mode turned fully OFF.
To reduce RF interference during phone calls, keep cell phones at least 12 inches from the Sierra controller and headset when making calls.
To gain peak performance from the ANR feature designed into your Lightspeed headset, it is necessary to have a solid seal around your ears. Without a tight seal, air can seep in and cause the ANR to compensate for uneven internal cup pressure, often resulting in a warbling noise. If you are experiencing this issue, please contact customer service so that we may assist you in identifying and correcting the problem. Customer service may be reached at: 1-800-332-2421 or [email protected].
The Sierra serial number (a small, white, bar-code sticker with numbers) can be found on the headset underneath the head pad. The head pad, located on the inner radius of the headband, must be removed to reveal the serial number. Simply pinch the cushioned middle part of the head pad, pull straight down, the cushion will invert, and you will see the sticker on the headband.
